1, according to the technical parameters required for the length of the band saw the corresponding band saw blade, saw tooth with tooth shape should be based on the material shape, cutting machine should be adjusted before the machine, as follows: As well as the material to choose.

2, will be ready to set the band saw blade on the two saw round and card into the steering wheel and guide the central, and then make the band saw tension.

3, check the three-phase power contact is good, pumps, band saw, the motor running in the right direction. Second, the operation of machine tools: cutting the preparation before the preparation is complete, you can operate the machine according to the following procedures for normal cutting: the workpiece hanging to the table and the shelf, the workpiece parallel to the work surface, and then move the workpiece To a position in contact with the plane of the scale device.